Blog #2 Finishing up my wrench

This week I feel like I got a lot done. My wrench is about 98% done. I started over due to my first wrench being to big and my cutting skills showed no knowledge. So I got a new piece of metal this one needed a lot more work due to the amount of rust on it. But that was not a problem I learned how fill very good from the help of my instructor I leaned how to take out all cruves, holes, or marks from my cutting. All surfaces were working and made nice. I learned how to size my wrench to the 2 inch nut. I used the vice i tightened the wrench with the nut in it so it fit perfectly. Making a wrench I gained a lot of knowledge about how to cut with the torche and setting the flame. And lastly how to use the drill press to make a  hole in my wrench. 

This picture shows the filling work I did on the right is my new wrench on the left is my first wrench that I trashed. 

Finished product on the left and the first wrench on the right. 

Learned how to write my last name in metel with a engraver.