My assignment was to take off the cab. Which means I had to disconnect all the hydraulic fittings going to the controls to use the forks on the forklift. In class I leanred a lot about saftey measures that I need to consider while working with hydraulics. I leanred that if the fluid gets shot into your skin and you don't go to the doctors quick you can start to say bye to some fingers maybe even a hand. Here is a picture of my work....
If you notice I used colored zip ties to make sure I know where all the hoses go if I need to reinstall them. Then I bleed out all the fluid into a pan. From this I leanred about safety when working with hydraulics and how to distinguish which line goes where by color coding, and then a good way to empty out the lines. In the last picture you can notice I also cut the coolant hoses and I drained all the coolant into a pan.
After I was done with my part of the project I was told to put new brakes on a trailer. Here is a picture...
I put on new brake shoes and a drum. Then adjusted the slacks on both sides of the axle so that the slack is at 1.25 inches.
